21

You need:

Good quality shampoo and conditioner.
Hairbrush
Heating Serum
Teasing comb
Flat Iron
Hairclip
Hair Spray

What to do:

Begin with a clean hair: wash your hair, towel dry it for 10-15 minutes and then blowdry until it’s completely dry.
Plug-in your flat iron. While it’s heating apply a heating serum to prevent your hair from any damage and them brush your hair to get rid of any knots and to distribute the product.
Divide your hair in two layers: top and bottom. Clip your top layer and start straighten yout bottom layer. After that, release the top layer and straight them too.
If you have bangs brush them to your right and straight them too.
Now it’s time for teasing your crown hair: while holding your hair straight up, take your comb and backcomb the hair about 1 inch from the scalp. Backcomb means combing only the back part of the hair in a downward motion, not a crating-type of motion. You want to comb down and take the comb out. Repeat this like 4-5 times. If you do this right, the back part of the teased hair should look knotty.
After backcombing, spray a little bit of spritz or hairspray at the root of the teased section, close to the scalp.
Take a paddle brush and smooth over the top of the teased area. Do not brush hard or you will take the volume out.
Now take your crown hair that you’ve just teased and clip it on your back (look at the pics if you’re confused).
Take another hairclip and clip a small hair from your bangs to your right along with your hair (look at the pics if you’re confused again).
Spay a little hairspray again and you’re done!


Enjoy your new look!